Network Cabling Glendale, CA | Cat6 & Cat6A Installer
Network cabling in Glendale
The most common cabling call we get from Glendale is a tenant improvement on Brand Boulevard or Central Avenue. A firm moves into a suite that was wired ten years ago, half the jacks are dead, the patch panel is a mess and nobody knows which cable goes where.
Book a free Glendale site survey Call (442) 222-2775 Text usNetwork Cabling done right for Glendale businesses
We pull new Cat6 or Cat6A from a clean patch panel to every desk, conference room and printer, label both ends, test and certify every run and hand you a printed map.
The second most common call is a dealership on South Brand or a warehouse off San Fernando Road where the office got wired and the shop, the parts counter and the service drive never did. Those runs are longer and go through block walls, metal deck and outdoor conduit, so we plan them on a site survey first. We also handle new construction, where we rough in cable with the framing and come back for trim after drywall, and we coordinate with the general contractor's schedule.
We terminate to TIA-568-B, keep bends and bundles within spec, and separate low voltage from power. Plenum cable goes above drop ceilings that carry return air, riser cable between floors. Every run is documented so the next tech — ours or yours — can find it in a minute.
What is included
- Cat6 and Cat6A structured cabling, plenum or riser rated to match your ceiling and code
- Patch panels, racks, cable management and a labeled, documented closet
- Certification testing on every drop with a printed test report
- Voice, data, PoE camera and access-point drops on the same run
- Conduit, J-hooks and pathways that pass inspection
- Moves, adds and changes after the install without a full re-pull
Free site survey in Glendale
We walk the property, count what you need and give you an itemized quote — free, no obligation.
Book itServing all of Glendale
ZIP codes 91201, 91202, 91203, 91204, 91205, 91206, 91207, 91208, 91210, 91214. Nearby: Pasadena, Los Angeles, Santa Monica, Long Beach.
Network Cabling across Glendale
Downtown office cabling in Glendale means working through shared risers in buildings on Brand, Central and Broadway and following the property manager's rules on hours and fire-stopping. In the San Fernando Road industrial corridor and around Grand Central, Air Way and Flower Street, the buildings are concrete and tilt-up with long open spans, so we use J-hooks and conduit rather than ceiling tile. Medical offices near Adventist Health Glendale on Wilson Terrace and Glendale Memorial on South Central need cabling that supports imaging and phones on separate VLANs. Montrose shops on Honolulu Avenue are usually small, older buildings where the run is short but the path is tricky.
Survey, install, document
Survey
We walk the space, count drops, trace pathways and check the closet, power and ceiling type. Free, and usually the same week.
Install
Cable is pulled in bundles, dressed, terminated to TIA-568 standards and labeled at both ends.
Certify
Every drop is tested with a certifier and you get the report, a drawing and photos of the closet.
Network Cabling in Glendale — questions we get
How much does Cat6 cabling cost per drop in a Glendale office?
There is no honest per-drop number without seeing the building. A drop in a downtown Glendale suite with an accessible ceiling and a nearby closet costs far less labor than one that has to cross a concrete floor or go through a shared riser. Cable count, distance, ceiling type and whether the building requires after-hours work all matter. We give a firm written quote after a free site survey.
Should I run Cat6 or Cat6A in a new Glendale office?
For most Glendale offices Cat6 is plenty for desks, phones and printers. We recommend Cat6A when you are cabling for Wi-Fi 6E access points, a video production floor like the studios around Grand Central, or anywhere you expect 10-gigabit runs to last the length of your lease. The difference in material cost is small compared with re-pulling later. We will show you both options on the free site survey.
Can you certify and label existing cabling in my Glendale building?
Yes. If you inherited a mess of unlabeled cable in a suite on Brand Boulevard or a warehouse in Tropico, we can tone out every run, test and certify it, label both ends and rebuild the patch panel. Runs that fail get flagged for replacement. You end up with a labeled map you can hand to any IT vendor. It usually takes a day for a typical office, and the free site survey tells us how much you actually have.
How long does a network cabling install take?
A typical office of 20 to 60 drops is one to three days. Larger buildouts are scheduled in phases so your team keeps working. After the free site survey you get a firm schedule with the itemized quote.
Cat6 or Cat6A — which should I choose?
Cat6 handles 1 Gbps at 100 meters and 10 Gbps at short runs, and is the right choice for most offices. Cat6A carries 10 Gbps the full distance and supports higher-power PoE, so we recommend it for new builds, Wi-Fi 6E/7 access points and anything you plan to keep for 15 years.
Do you label and test every cable?
Yes. Every drop is labeled at the jack and the patch panel, certified with a tester, and you receive the test report. Untested cabling is where intermittent network problems come from, so we do not skip it.
Other low voltage services in Glendale
Industries we serve in Glendale
Local guide: Security camera laws, permits and placement for Glendale businesses (2026 guide)
Let's walk your Glendale property — on us
Fill out the form and you will hear from us fast — usually the same day. Or skip the typing:
Call or text (442) 222-2775 — we answer.
Text us · Email tech@itech2.co
Have a question first? Read the FAQ or see who does the work.
Main office line: (866) 904-8787 · Licensed C-7 #1098090 · Since 2010